Skip to Content

Case Studies

Documented challenges, solutions, and outcomes from real projects.

High-Efficiency AC Installation in Mueller
AC Installation

High-Efficiency AC Installation in Mueller

Mueller, TX

Full replacement of an aging 3-ton air conditioner with a high-efficiency 16 SEER2 system for a two-story home in Mueller. The project included a new condenser, matched evaporator coil, and a fresh pad and disconnect.

Outcome: The upstairs bedrooms now hold within 1 to 2 degrees of the first floor, and the variable-speed compressor runs at low stage through most of the afternoon instead of short-cycling. The homeowners reported a noticeable drop in their first summer electric bill and said the house finally feels comfortable during peak heat. Our follow-up static pressure and temperature-split readings confirmed the system was operating well within manufacturer specification. All work passed final inspection and the equipment was registered for the full warranty term.

Furnace Repair Restores Heat in a Hyde Park Bungalow
Furnace Repair

Furnace Repair Restores Heat in a Hyde Park Bungalow

Hyde Park, TX

Diagnosis and repair of a gas furnace that would not fire during the first hard cold snap of the season. The fix focused on a failed hot surface igniter and a restricted flame sensor.

Outcome: The furnace fired on the first call and reached the thermostat setpoint in under fifteen minutes, restoring heat the same evening. Combustion readings came back within the acceptable range, giving the homeowner confidence that the equipment was operating safely. We installed a new carbon monoxide alarm near the closet as a precaution and walked the homeowner through filter changes and annual service timing. The furnace has run without a repeat lockout through the rest of the heating season.

Whole-Home Ductwork Replacement in Tarrytown
Ductwork Replacement

Whole-Home Ductwork Replacement in Tarrytown

Tarrytown, TX

Replacement of crushed and leaking flex duct with a sealed, hard-pipe trunk system for a 1960s Tarrytown ranch home. The project also addressed severe static pressure issues that were straining the air handler.

Outcome: Static pressure dropped from well above the limit to a comfortable range, and the air handler runs noticeably quieter as a result. The far bedrooms now receive airflow comparable to the rest of the house, and the homeowner no longer needs portable fans to sleep comfortably. Post-project testing showed duct leakage reduced to a small fraction of the original figure, and the homeowner reported a steady drop in summer utility costs over the following months.

Cold-Climate Heat Pump Installation in Clarksville
Heat Pump Installation

Cold-Climate Heat Pump Installation in Clarksville

Clarksville, TX

Installation of a variable-speed heat pump to replace an aging gas furnace and condenser pair in a renovated Clarksville cottage. The system was selected to handle both Austin summers and occasional hard freezes.

Outcome: The home now heats and cools from a single system with no gas connection in use, and the homeowners were pleased to see the utility bill stay flat despite the added square footage. During the following January cold snap, the heat pump held the setpoint without relying on strip heat for extended periods. Supply air is noticeably steadier than the old furnace, and the equipment runs quietly enough that it is barely audible from the living room. The installation passed inspection and the homeowners referred a neighbor the following spring.

Smart Thermostat and Zoning Controls Upgrade in Westlake Hills
Thermostat & Smart Controls

Smart Thermostat and Zoning Controls Upgrade in Westlake Hills

Westlake Hills, TX

Replacement of three legacy thermostats with smart controls and a zoning interface for a hillside home with wide temperature swings between levels. The upgrade included remote sensors and scheduling tailored to occupancy.

Outcome: Temperature variation between levels narrowed to within about 2 degrees, and the upper bedrooms now cool down on schedule before bedtime. The homeowners can check and adjust the system from anywhere, and they used the runtime reports to confirm the equipment was cycling less than before. Filter reminders have kept maintenance on track, and the system has logged no fault codes since installation. They described the upgrade as the first time the house has felt consistently comfortable on every floor.

Commercial HVAC Retrofit for an East Austin Office Building
Commercial HVAC Retrofit

Commercial HVAC Retrofit for an East Austin Office Building

East Austin, TX

Retrofit of a 12,000-square-foot creative office with new split systems, upgraded controls, and reconfigured distribution to replace a failing rooftop package unit. The work was phased to keep the building occupied throughout.

Outcome: The building now maintains setpoint across all zones, including the conference rooms that previously overheated during meetings. Splitting the load means a single equipment failure no longer takes down the whole space, and the owner has remote visibility into performance from a phone. Measured electrical demand dropped compared with the old single-unit operation, and the property manager reported fewer after-hours comfort complaints. The project was completed without a single lost business day.

Emergency HVAC Repair During a Round Rock Heat Wave
Emergency HVAC Repair

Emergency HVAC Repair During a Round Rock Heat Wave

Round Rock, TX

Same-day emergency service for a family whose air conditioner stopped cooling during a triple-digit heat wave. The repair restored cooling within hours of the call.

Outcome: Cooling was restored within about two hours of arrival and the house returned to a safe temperature before the hottest part of the day. The homeowner was relieved to have the infant and elderly family member back in a comfortable space the same afternoon. We noted the equipment's age and remaining expected life so the family could plan a replacement on their own timeline rather than under emergency pressure. The system has run without a repeat failure since the repair.

Rooftop Unit Replacement for a Cedar Park Retail Center
Rooftop Unit Replacement

Rooftop Unit Replacement for a Cedar Park Retail Center

Cedar Park, TX

Replacement of two end-of-life rooftop package units serving a multi-tenant retail center in Cedar Park. The project included new curbs, economizers, and updated disconnect and control wiring.

Outcome: Both units now hold setpoint reliably through the afternoon peak, and the economizers have cut compressor runtime noticeably during mild months. The tenants reported no comfort interruptions during the changeover, and the property owner has a service plan in place with the full parts warranty registered. Amp draw readings on the new compressors are well within nameplate ratings, indicating the equipment is not being overworked. The rooftop curbs and flashing passed inspection with the roof warranty intact.

No case studies found.