AC Repair
Fast diagnosis and repair for an air conditioner that is blowing warm air, short-cycling, or leaking water.
When an air conditioner stops cooling in Austin, TX, the cause is often a failed capacitor, a dirty evaporator coil, a refrigerant leak, or a compressor struggling through another triple-digit afternoon. We diagnose the system on site and explain what is actually failing before recommending any repair.
Work covers air handlers, condensers, blower motors, contactors, drain lines, and thermostats for both homes and light commercial spaces. Because Austin's humidity keeps drain pans full, we also check for clogged condensate lines that can shut a system down or cause water damage near the unit.
What's Included
- On-site diagnosis of no-cooling and warm-air complaints
- Capacitor, contactor, and relay replacement
- Refrigerant leak detection and recharge
- Evaporator and condenser coil cleaning
- Blower motor and air handler repair
- Condensate drain clearing to prevent water damage
- Thermostat calibration and control troubleshooting
- Clear explanation of the repair before work begins
Related Case Studies
High-Efficiency AC Installation in Mueller
Mueller, TX
Full replacement of an aging 3-ton air conditioner with a high-efficiency 16 SEER2 system for a two-story home in Mueller. The project included a new condenser, matched evaporator coil, and a fresh pad and disconnect.
Outcome: The upstairs bedrooms now hold within 1 to 2 degrees of the first floor, and the variable-speed compressor runs at low stage through most of the afternoon instead of short-cycling. The homeowners reported a noticeable drop in their first summer electric bill and said the house finally feels comfortable during peak heat. Our follow-up static pressure and temperature-split readings confirmed the system was operating well within manufacturer specification. All work passed final inspection and the equipment was registered for the full warranty term.
Furnace Repair Restores Heat in a Hyde Park Bungalow
Hyde Park, TX
Diagnosis and repair of a gas furnace that would not fire during the first hard cold snap of the season. The fix focused on a failed hot surface igniter and a restricted flame sensor.
Outcome: The furnace fired on the first call and reached the thermostat setpoint in under fifteen minutes, restoring heat the same evening. Combustion readings came back within the acceptable range, giving the homeowner confidence that the equipment was operating safely. We installed a new carbon monoxide alarm near the closet as a precaution and walked the homeowner through filter changes and annual service timing. The furnace has run without a repeat lockout through the rest of the heating season.
Whole-Home Ductwork Replacement in Tarrytown
Tarrytown, TX
Replacement of crushed and leaking flex duct with a sealed, hard-pipe trunk system for a 1960s Tarrytown ranch home. The project also addressed severe static pressure issues that were straining the air handler.
Outcome: Static pressure dropped from well above the limit to a comfortable range, and the air handler runs noticeably quieter as a result. The far bedrooms now receive airflow comparable to the rest of the house, and the homeowner no longer needs portable fans to sleep comfortably. Post-project testing showed duct leakage reduced to a small fraction of the original figure, and the homeowner reported a steady drop in summer utility costs over the following months.
Other Services
AC Installation
Get a properly sized, efficient air conditioner that holds a comfortable temperature through Austin's longest summer days.
Read MoreEmergency HVAC Repair
Urgent help when your cooling or heating fails and an Austin home or business needs relief right away.
Read MoreFurnace Repair
Restore dependable heat with careful diagnostics and honest repair-or-replace guidance.
Read More