Ductwork Replacement
Fix uneven rooms and wasted energy with ductwork rebuilt for Austin's attic heat and humidity.
Attics in Austin regularly reach temperatures that cook older flex duct, and leaks or crushed runs are one of the most common reasons a home feels uneven from room to room while utility bills climb. We evaluate duct condition, sizing, and routing, then replace failing sections or the entire distribution system.
New ductwork is sealed at joints and boots, supported properly, and balanced so bedrooms and living areas receive airflow in proportion to their size. For commercial properties, we can also address rooftop curb transitions and zoned duct layouts that no longer match how the building is used.
What's Included
- Full duct evaluation for leaks, crushing, and poor sizing
- Attic duct replacement built for Central Texas heat
- Sealed joints, boots, and plenum connections
- Flex and rigid duct options for tight layouts
- Return air improvements for better system balance
- Room-by-room airflow balancing after installation
- Zoned layouts for commercial buildouts
- Cleanup of old duct material after removal
Related Case Studies
High-Efficiency AC Installation in Mueller
Mueller, TX
Full replacement of an aging 3-ton air conditioner with a high-efficiency 16 SEER2 system for a two-story home in Mueller. The project included a new condenser, matched evaporator coil, and a fresh pad and disconnect.
Outcome: The upstairs bedrooms now hold within 1 to 2 degrees of the first floor, and the variable-speed compressor runs at low stage through most of the afternoon instead of short-cycling. The homeowners reported a noticeable drop in their first summer electric bill and said the house finally feels comfortable during peak heat. Our follow-up static pressure and temperature-split readings confirmed the system was operating well within manufacturer specification. All work passed final inspection and the equipment was registered for the full warranty term.
Furnace Repair Restores Heat in a Hyde Park Bungalow
Hyde Park, TX
Diagnosis and repair of a gas furnace that would not fire during the first hard cold snap of the season. The fix focused on a failed hot surface igniter and a restricted flame sensor.
Outcome: The furnace fired on the first call and reached the thermostat setpoint in under fifteen minutes, restoring heat the same evening. Combustion readings came back within the acceptable range, giving the homeowner confidence that the equipment was operating safely. We installed a new carbon monoxide alarm near the closet as a precaution and walked the homeowner through filter changes and annual service timing. The furnace has run without a repeat lockout through the rest of the heating season.
Whole-Home Ductwork Replacement in Tarrytown
Tarrytown, TX
Replacement of crushed and leaking flex duct with a sealed, hard-pipe trunk system for a 1960s Tarrytown ranch home. The project also addressed severe static pressure issues that were straining the air handler.
Outcome: Static pressure dropped from well above the limit to a comfortable range, and the air handler runs noticeably quieter as a result. The far bedrooms now receive airflow comparable to the rest of the house, and the homeowner no longer needs portable fans to sleep comfortably. Post-project testing showed duct leakage reduced to a small fraction of the original figure, and the homeowner reported a steady drop in summer utility costs over the following months.
Other Services
AC Installation
Get a properly sized, efficient air conditioner that holds a comfortable temperature through Austin's longest summer days.
Read MoreAC Repair
Fast diagnosis and repair for an air conditioner that is blowing warm air, short-cycling, or leaking water.
Read MoreEmergency HVAC Repair
Urgent help when your cooling or heating fails and an Austin home or business needs relief right away.
Read More